avabas.blogg.se

Comant antenna installation manual
Comant antenna installation manual









comant antenna installation manual

But we are the first with a specially designed, Iridium only aviation patch that meets and earned the new FAA TSO C159a for satellite communication. Other aviation antennas must go “wide-band” to capture the nearby GPS frequency for FAA TSO which reduces efficiency. Hopefully that’s not the problem.Our low-profile Iridium antenna is Iridium-frequency-only allowing its narrow-band tuning to provide optimum Iridium performance. I didn’t include the optional CAN Bus terminator block because I didn't connect it into the CAN Bus. Yes, I wired Pins #5 & 6 into the GTX 23EX pins #24 and 50. I followed Cubcrafters’ wiring diagram (schematic attached). I didn’t wire the GPS 20A into the CAN Bus. Pls remind me, it’s in the Config Page (hold the MENU button) in System Info? I purchased the ‘Executive Touch panel’ (G3X, etc) directly from Cubcrafters in 2015, so there’s a possibility that it’s below v8.0, but I’ve kept the CAN Bus components software up-to-date. I’ll check the software version on the GTX 23ES (good thinking!). The key GPS connection is between pins 5 and 6 of the GPS 20A going to (respective) pins 24 and 50 on GTX 23.Thanks Andrew! Very helpful. According to the Garmin documentation, there is no configuration required for the GTX 23ES and GPS 20A if connected per their (G3X) installation manual. Second, does the GPS 20A connect via direct serial connection to the GTX 23ES? Assuming a G3X touch avionics suite, the GPS 20A should have two data connections, CAN Bus to the G3X and RS-232 serial directly to the transponder. Not knowing the details of the installation, I would look for two possibilities.įirst, does the GTX 23ES have software version 8.00 or higher? Looks like Dec 2015 is when that version was released, so if the unit is newer than 2015, it should work for ADS-B "out". That looks like it points to the GPS 20A interface to the GTX 23ES transponder.

comant antenna installation manual

These appear to pertain to ADS-B (GPS) position source. According to AC 20-165, SIL stands for Source Integrity Level, and SDA stands for System Design Assurance.











Comant antenna installation manual